Description Upgrade your Glock without overcomplicating it. This is a trigger shoe only, designed to pair with your factory trigger bar, and it includes a roll pin punch to make installation quick and straightforward. Engineered for feelWe built this flat-faced trigger to improve reset and overall feel while keeping the reliability of a stock setup. The geometry delivers a cleaner, more consistent pull, and the wide chamfers eliminate the sharp edges that can dig into your finger. No matter where your finger lands, it feels right. Built to lastMachined from 7075 aluminum and finished in Type III hard anodize, this trigger is made to hold up. There are no set screws, no adjustability, and no unnecessary parts. Fewer components mean fewer failure points. The V2 safety is machined from stainless steel for added durability where it matters most. Proven reliabilityBy retaining the factory trigger bar, all three Glock safeties remain intact. No spring changes, no connector swaps, no guesswork. You get the dependability of the original system with a refined trigger feel. Simple installSwap your factory trigger shoe onto this one in just a few minutes. Disassemble, transfer the trigger bar, tap in the preinstalled pin using the included punch, and reassemble. No fitting or tuning required. What’s included– Trigger shoe (preinstalled pin)– Roll pin punch ImportantProper installation is critical to safe function. Always confirm operation after reassembly. If you’re unsure, have a qualified gunsmith handle or inspect the install.
